Fire Retardant Coating for Electrical Cables

Cable Fireproof Coating KC2000

◆ Completely meet the requirements of GB 28374-2012;

◆ Environmental protection halogen-free, non-toxic and harmless;

◆ Good flexibility;

◆ Good insulation performance;

◆ Strong adhesion;

◆ Good fire protection effect;

◆ Good anti-corrosion performance.

Inquiry now

product introduction

Product Instruction

KC2000-E is a new type of fireproof coating for cable developed by our company according to GB 28374-2012 national standard. The product can produce uniform and dense spongy foam coating when subjected to fire, which can effectively inhibit and block the spread of flame. It can be used for fire protection of power cable body and joint, and also can be used for fire protection of cable thread at the bottom of switch cabinet. It has the advantages of environmental protection, no pollution, non-toxic and tasteless, strong adhesion and good flexibility.

Applications

Fire protection of cable body and joints

Fire protection for cable threading at the bottom of switchgear

Product Specification

Test Item	Typical Value	Test Standards
The state in the container	No caking, uniform state after stirring	visual
fineness	≤90μm	GB/T 6753.1
viscosity	≥70s	GB/T 1723
Table dry time	2~2.5h	GB/T 1728（Method A）
Full set time	About18h	GB/T 1728（Method A）
Oil resistance	No wrinkling, peeling or blistering after soaking for 7d	GB/T 28374-2012
Resistant to salt water	No wrinkling, peeling or blistering after soaking for 7d	GB/T 28374-2012
The wet and heat resistance	After 7d test, there was no cracking, peeling or blistering	GB/T 28374-2012
Resistance to freezing and thawing cycles	After 15 cycles, no wrinkling, peeling and blistering were observed	GB/T 28374-2012
Flex resistance	No layer, no peeling, no foaming	GB/T 28374-2012
Flame retardant	Carbonization height ≤2.50m	GB/T 28374-2012

Direction for Use

1. Before construction, clean the cable surface of dust, oil, impurities, etc. and carry out the construction of fireproof coating until the cable surface is dry;

2. When using, the fireproof coating should be fully stirred evenly;

3. Brush for 3 times, with an interval of 4h for each time and a thickness of 0.3~0.4mm for each time. The final coating can be formed after drying and the final coating thickness is about 1mm.

4. During the construction and before the coating is dry, it should be waterproof, anti-insolation, anti-pollution, anti-movement and anti-bending. If there is any damage, it should be repaired in time;

5. After the completion of construction, the coating should be uniform and smooth, with no obvious bump on the surface.

Package

25kg/barrel

Certificate

Leave A Message

If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Subject : Cable Fireproof Coating KC2000

Tags :

Related products

High Temperature Resistance Fireproof Tape KC70

◆ Can be used to splice and terminate cable, to avoid fire

◆ Physical and electrical properties are unaffected by the degree of stretch.

◆ Self-fusing tape.

◆ Heat resistance;

◆ Resistance to ozone, UV and xenon exposure;

◆ Operation and installation easily.

Heat-absorbing and Fireproof Blanket KC9000

KC9000 heat-absorbing and fireproof blanket is a fireproof product that can be directly coated on the external protection of equipment, power cable, cable bridge, etc., which can effectively prevent flame spread and reduce the serious damage caused by high temperature conduction.

Metal Composite Fireproof Board KC8000

KC8000 is a metal composite fireproof board with heated expansion property, it is composed of stainless steel plate, fire layer, wire mesh, aluminum foil, totally four layers of structure.

High Temperature Non-solidified Fireproof Mastic KC7000

Thermal expansion,

Elastic material, good plasticity, easy to install and operate

It can be used for repeated installation

Good adhesion to the substrate, outdoor long-term use of no vertical flow

Environment-friendly, halogen-free formula

Asbestos-free, non-toxic

No volatile organic matter

Anti-condensation Moisture-controlling Tablets KC4000

Excellent hygroscopic performance, hygroscopic capacity can reach more than 80% of its own weight, sustainable moisture absorption in high humidity environment.

Can be used for a long time, the effect of performance does not decay

With excellent softness, light weight, installation is not limited by the environment, easy to use

At the same time has the function of moisture absorption, moisture release, maintain stable humidity

It can also be used normally under zero temperature and does not harden

Non-toxic environmental protection, can be directly discarded as ordinary garbage

Non-corrosive, no corrosion when in contact with the equipment in the cabinet

Reusable。

Fire Retardant Tape KC77

KC77 Fire Retardant Tape is a flexible tape with high expansion rate, fire prevention and heat insulation. It is mainly used for fireproof plugging of cracks around single or cluster cables, wind pipe, plastic pipe penetrations and metal penetrations. It has good water resistance, acid and alkali resistance, moisture and heat resistance, and freeze-thaw resistance. It is free of volatile organic matter, asbestos, fiber dust and other harmful substances, safety and environmental protection without pollution. It uses the combination of chemical expansion and physical expansion technology, rapid expansion in case of fire, with the rise of temperature formed with the strength of the carbonization layer tightly filled through the holes of the gap, block the spread of flame and smoke, with more than 3 hours of fire aging. At the same time, the product in the harsh, dirty and other outdoor environment, still can maintain the normal fire function.

Fireproof/Waterproof Sealant KC1002

KC1002 is a fireproof, waterproof sealant, specially designed for building and industrial fire sealing, excellent fire performance, has good weather resistance, high and low resistance and bonding

Moisture Proof Sealing Material KC3000

KC3000 Moisture proof sealing material is widely used for moisture proof sealing in distribution control cabinet, RMU, HV/LV switch cabinet, cable branch box, terminal box, pad-mounted transformer, mechanism operation box, assembly control unit, which has low viscosity, good fluidity and easy penetration, resistant to natural freeze-thaw cycle and all kinds harsh environment, while no deformation, no deterioration, no cracking.

With a variety of metal materials, cable sheath material can be closely bonded and not corroded, but also effectively prevent small animals from underground into the cabinet, reduce safety risks; to realize the closed cabinet moisture proof, prevent cable interlayer or channel from moisture, to provide reliable protection for production and operation equipment.

Categories